ขาย ST-Link V2 Mini STM8 STM32 Emulator Downloader Programming Unit คละสี ราคาที่ดีที่สุด

ST-Link V2 Mini STM8 STM32 Emulator Downloader Programming Unit คละสี ST-Link V2 เครื่องโปรแกรม STM32 รองรับ Arduino IDE ST-Link/V2 mini is a small form factor clone programmer and in circuit debugger for STM8 and STM32. This mini STM programmer is a low cost alternative, supports all STM32 SWD interface debugging and SWIM debugging for STM8 or STM32 series controllers. It can provide power to target 5V and 3.3V output. ข้อมูลเพิ่มเติม ST-Link V2 Mini STM8 STM32 Emulator - This programmer supports downloading and debugging of the full range of STM32 SWD and STM8 SWIM. - The wiring is very simple! It's convenient and practical because the interface definition is marked directly on the case. - It supports both 5V and 3.3V power outputs, and all I/O output ports are protected. - You can easily observe the working status with red and blue LED indicators. - It can protect your computer motherboard since the internal board of this programmer is with 500MA self-recovery fuse Supported Device Series: - STM8 Series Microcontrollers - STM32 Series Microcontrollers Supported Interfaces: - JTAG/serial wire debugging (SWD) - Single wire interface module (SWIM) Supported Development Environments: - ST-LINK Utility 2.0 and above - STVD 4.2.1 and above - STVP 3.2.3 and above - IAR EWARM V6.20 and above - IAR EWSTM8 V1.30 and above - KEIL RVMDK V4.21 and above วิธีการติดตั้ง ST-Link V2 Mini STM8 STM32 Emulator