ขาย Instant Heat Sealing Machine∪ ราคาที่ดีที่สุด

📜Goods: high power instant heat hand pressure sealing machine 📜Introduction: ✔️Flat line attached to the machine (general sealing) ✔️The other is a circular line (cut off the surplus after sealing) ✔️You can buy another round line.But the flat line on the platform should be replaced by yourself, please ✔️Hand pressure sealing machine is easy to operate and suitable for sealing plastic film. it can be widely used in food, special products, candy, tea, medicine and hardware industries. ✔️Can be used in general plastic film (plastic bag) and thin aluminum foil bag. 📜Specification data: ✔️Different sizes.The outer shape is slightly different. ✔️100 sealing machine can seal length 10CM... ✔️200 sealing machine sealable length 20CM ✔️300 sealing machine sealable length 30CM ✔️400 sealing machine sealable length 40CM ✔️Heating line and heating cloth are all supplies. ✔️Voltage: 110V 📜Method of use: Description of the use of sealing machine 1 when the pressure rod of the sealing machine is pressed down after the plug.The power red light will be on.Heating only begins - adjustments.The twist is marked by a scale of 1-8.That means the length of heating.For example, when you turn to the 2-pole press down, the light is on.The heating line begins to heat.Ca. 1-2 seconds light out auto power cut off - adjustment: adjustment according to the thickness of the bag and the results after sealing.Sealing is not tight. it is too little time.Fine-Tuning a little bit.Melting after sealing is too much time.You need to cut it a little.If the plastic melts and sticks to the cloth or strip.This will require the replacement of the strip and the heating cloth.That is, continuous use.There'S not enough cooling time for middle rest.It'S also easy to smell.Longer interval cooling time required - if the sealing machine is flat.Cannot be used to cut off or seal hot shrink film after sealing.Replace it with a circular line.Otherwise, the platform will be damaged. 5 there is no electricity after a while.Please replace the heating line.Loosen the screw of the iron under the pressure bar and see it. - rest for 5 minutes after 15-20 minutes of continuous use.Let the machine stand cool.To avoid damage to the machine desk.Thank you. The material is iron.But the shell is plastic.Cheap and good Use continuously for 15-20 minutes.Please be sure to suspend the use.Let the machine stand cool and rest.To avoid damage to the machine desk. Origin: china Welcome to the garage/studio lot!! ⚠️Points to note for commodity exchange⚠️ ❗️❗️Please make sure to video-screen the goods when they are opened to protect your rights and interests❗️❗️ ❗️❗️Commodity defects/breakage please within three days and chat to send a video of the broken disk❗️❗️ ⚠️We close the shop with the strictest quality of goods, take care of the rights and interests of our guests, and pay more attention to all goods in📦Minimize the risk of transport damage💌 ⚠️Some commodities may cause some burrs or scratches as a result