ขาย Edb * 2014 V1.3 Upa Usb โปรแกรมเมอร์ฟังก์ชั่นดิจิตอล Upa ราคาที่ดีที่สุด

#2014 #V1.3 #UPA #USB #Programmer #Nec #Function #Digitally #Signed #UPA #Chip #Tuning 2014 V1.3 UPA USB Programmer Nec Function Digitally Signed UPA Chip Tuning Features: 100% brand new and high quality This set of New UPA USB Programmer main unit used for main unit damaged. Software version: V1.3. Simply connect the mainboard to the UPA programmer directly or by using a DB9 male / female extension cable (1:1). Insert the correct config key into the slot of the mainboard and start programming either via the ZIF or SOIC Socket. You can also use the included DIL to 10pin Flat-ribbon header, put it inside the ZIF socket and wire up an SOIC clip or clamps for ISP use from there. Pick the Adapter you want to use, attach the flat cable to the Adapter (PIN1 is always indicated, on both the cable and also the Adapter) and also to the main board's 10pin ISP connector. Select the VCC supply source by the jumper on the mainboard next to the ISP connector (on = tar get supplied from upa, off = tar get got own supply). Slide the Adapter over the soldered PLCC MCU on the tar get PC B. (No soldering, no pinout reviewing, no pin counting, saves lots of time and hassle and let's you make your job faster, precise and easier) Once your workshop is equipped with our Adapter Set you will have a all new UPA Experience. Specification: Material: ABS Size: As Shown Package Includes: 1x UPA Programmer 1x USB Cable 1x Mainboard with 40pin Dil Zif (600mil) Socket and 14pin Soic Zif (150mil) Socket note: 1.Please allow 1-2cm errors due to manual measurement, make sure that you do not mind before you order. 2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. 3.This set of New UPA USB Programmer main unit, do not contain Adapters.