ขาย ASD Pressure Cooker Gas 304 Stainless Steel Pressure Cooker Three-layer Compound Bottom Six Insurance Pressure Cooker ราคาที่ดีที่สุด

Material type: 304 stainless steel applicable stove: induction cooker, gas stove Stainless steel cookware maintenance(All kinds of pots, such as steamer, milk cooker, pressure cooker, etc. can be applied)Stainless steel pot is black?Clean and dry in time after use, and use medium and small fire to avoid big fire, which can effectively avoid blackening of the pot body.Stainless steel pot is sticky and dirty and difficult to wash?Add water to the big pot, put in some pineapple peel, put in the smaller pot, boil it for 20 minutes, cool it down and take it out, it is as bright as new!There are white spots inside the pot?White spots in stainless steel cookware may be caused by impurities in local water, which adhere to the stainless steel surface and can be cleaned.Is the stainless steel pot burnt?Take a few tomatoes that are not very good and put them in a pot, and they will naturally fall off. Or cut some oranges and put them in a pot to boil, and stew for one night, and the paste will turn over the next day, which is very easy to remove. Tips for pressure cooker maintenance Excessive soup spouted from pressure limiting valve? 1、 Excessive firepower 2、 Excessive food capacity There is dirt on the pressure cooker? Cut the used toothpaste skin, beat it flat, and leave the residual toothpaste on it. Wipe the surface of the pot directly, and finally rinse the toothpaste and dirt with clear water. You can also smear a little vinegar on the stains of pots and pans, and clean them with clean water after standing. Precautions for using pressure cooker one Do not burn it dry. 3. Don't put in too many ingredients and don't use too much firepower 4. Don't use soda, a lot of oil and alcohol. Do not move the cooker during heating. 4. When exhausting air except the pressure limiting valve, the heating source must be turned off immediately. Open the lid only after all the steam has been drained. 5. Don't put the pot in water at high temperature, especially at the handle, which is easy to crack because of the alternation of cold and hot. seven 6. It is suggested that the service time of sealing aprons should not exceed two years.