ขาย 2-4 s 2 ch single - way brushed esc 12ax 2 อุปกรณ์ควบคุมสําหรับ rc เครื่องบินเร็ว ราคาที่ดีที่สุด

Durable 2-4S 2CH Single-way Brushed ESC 12AX2 Unidirectional ESC Differential Speed Controller for RC Speedboats Mini Airplane Models Description:  This ESC is suitable for differential speedboats and small aircraft. The latest version of the PCB enhances heat dissipation and thickens the line (the battery line is upgraded to 18AWG and the motor line is upgraded to 20AWG).  The low throttle is activated to prevent the unsafe of the high throttle motor from rotating. (Started below PWM 1150)  With starter sound (The prompt sound is caused by high-frequency current vibration motor, the sound size varies depending on the motor; small motor may be slightly rotated by the current)  With out of control protection (lost signal (here the ESC signal line is broken), the motor stops) There are 2 modes: Speed difference mixing mode:  Mixing = Throttle X 100% + Direction X 100% (This ratio is determined by multiple tests and feedback from the model)  If you open the 50% throttle and then the direction to the left, the left motor will be reduced by 50% and the right side will be increased by 50%. The result is that the left motor is stopped (ie the throttle 50% - direction 50% = 0) , the right side is full (ie the throttle 50% + direction 50% = 0)  If you open the 100% throttle and then turn to the left, the left motor will be reduced by 50% and the right side will be increased by 50%.  The result is that the left motor turns 50% (ie the throttle 100% - direction 50% = 50) %), the right side is full 100% (the throttle 100+ direction 50% = 150%, but the motor output is also 100% maximum)  2CH synchronization (a special case of mixing mode)  Single yellow line is not inserted (it is equivalent to invalidating the differential signal). The output of the two motors is the same. The rudder is suitable for double thrust. 2CH independent mode:  It is equivalent to two independent ESCs  The signal of the 3-wire port controls the motor that is close to the battery line.  1 line port signal, control another motor Specification:  Type: 12Ax2  Voltage: 6-16S (2-4S)  Current: 12A/CH (Use 120A MOS tube ESC, the peak is far more than 12A)  BEC output: 5V 1.5A  Size: Approx. 45x20mm  Remote control signal: PWM (1000-2000)) (1100-1900) automatic adaptation of the run Package:  1x ESC